LIKE PAGE ĐỂ ĐƯỢC HỖ TRỢ
- Tự ngắt khi đầy.
- Đèn đỏ đang sạc, đèn xanh đầy pin
- Bảo vệ pin không bị quá áp, không cháy nổ, rất an toàn.
Switch Description Use
1, the battery is positive inward (lamp side), the negative outward (aft).
2, the rear switch, the switch function Cheon switch is a switch function, tap the switch is dimming function.
two. Board Instructions
1 OUR torch using advanced voltage constant current technology, can effectively solve the LED flashlight on the constant current regulator requirements.
2, Special Note:. A Do not use excess pressure, battery voltage should not exceed 4.2V b positive root forward, not inverted, otherwise it will burn control board c note torch temperature changes, to ensure the cooling d non-professionals... Do not open the circuit board
3. Warranty: open or treated board no longer warranty.
three. Lithium battery Description
1, the lithium battery characteristics: lithium batteries and battery charging in a completely different way; lithium batteries have no memory, rechargeable at any time, do not overcharge and over discharge.
2, the first charge 6 hours at least, after the green light on the charger according to it, will not overcharge.
3. Special Note To use anti-overcharge, anti-reverse, anti-short circuit "three" charger;
4, for a long time do not use the battery should be fully charged to save, normal in about three months and then charge and discharge;
four. Flashlight instructions
1, the torch is in use, according to the torch voltage and battery requirements for selection, not to abuse, to prevent burn circuit boards, different models, different voltage batteries Do not use.
2, in use, when the brightness of the flashlight change significantly when you want to close the torch, causing the battery to prevent over-discharge.
3, cooling techniques: the torch during use, to ensure heat dissipation. Strongly urge the battery is fully charged, it is best to use second gear, this can make the caps and flashlight batteries are extended product life! You can not direct people's eyes light flashlight, ultra-bright glare, so as not to affect vision, especially children.
Fives. Troubleshooting
1. Check Battery: Make sure the battery has power and installed batteries in the correct direction, do not use different brands of batteries not mix old and new batteries.
2, check the tail cap: Make sure the switch has been tightened and good contacts to ensure that the end cap and the end cap pillars pressed sheet metal ring good contact, watch cap is loose.